Kiss GUI does not show serial config "VTX"

[HunnetsAU]

I am trying to setup Kiss LUA script for Taranis X9D+ with kiss FC v1.03 and Mr Steele PDB.

I have TBS Unify HV, PDB is soldered for 7v and I have smart audio running from Unify to Audio on the Steele PDB and then from Audio to RX3 on Kiss FC. My X4r is also connected to the Aux1 on the Kiss FC.

I believe my problem is caused as when I connect the FC to the Gui I dont have the option to select VTX from the serial Config, only options for OSD and Logger.

Firmware:
Kiss FC = RC34c
Kiss Gui = 2.0.6
Steele PDB = v2.5
Lua Script - 0.9

Any help in wiring this up correctly would be appreciated.

[maripuusiim]

Can you set PIDs on taranis with that setup? For OSD settings FCv2 is needed, maybe also for VTX(same problem here with v1.03 and RC34c).

[HunnetsAU]

Cant set PIDs either.

I have also just built a second quad with the exact same setup as above however, TBS unify V3 (5 volts) with the 5v bridge on Mr Steele PDB. Same problem arises where I can't get any update on the lua script for the taranis.

[lichtl]

what receivers are you using? there was a problem with certain firmware versions for xsr.